Thread: The Hardness Of The Depressed Grinding Disc In Stock

Forum: Searching for a room

Author juniperqq


juniperqq - 26/12/2018 at 11:44

Nowadays, the depressed grinding disc in stock technology is more and more developed, mainly because of the needs of the industry, the need of cutting technology, and the hardness technology of the cutting piece is also getting higher and higher. The cutting piece is made of high-strength resin and preferred special abrasive, which are allowed. The linear speed is more than 50 m / s, which is not easy to be brittle. The cutting is sharp, the cutting heat is very small, and the heat of the cutting piece sample is shallow, so as to minimize the interference. The grinding disc cutting piece talks about the importance of the hardness of the cutting piece.

The depressed grinding disc in stock is widely used in machinery, automobile, shipbuilding, metallurgy, chemical industry, etc. It can also be used in the decoration and equipment repair of modern houses and workshops.

Superhard abrasive itself has extremely high hardness so it can process all kinds of the depressed grinding disc in stocks, especially materials that are difficult to process with ordinary abrasives. For example, diamond abrasives are used to process hard alloys and ceramics.

NickJohn - 3/1/2019 at 19:24

That's wonderful by the way when you write and share some quality information like this, do you know that our bookburningparty is the best place where you can grow income, let's find out a way to earn some respectable money over here.

This thread come from : Lappis.org | The student community in Stockholm
http://www.lappis.org

Url of this website:
http://www.lappis.org/modules.php?name=mxBoard&file=viewthread&fid=14&tid=3121