You definitely know a lot about the performance of the T41 4 inches cutting disc size , so you probably don't know about the factors that affect its efficiency. So what are the specific factors? Today, the Aurora Abrasives will give you a brief introduction.
Several factors affecting the dimensional effect of the T41 4 inches cutting disc size:
1. Sawing depth: The sawing depth is an important parameter related to diamond wear, effective sawing, the force on the saw blade and the nature of the stone being sawed. Generally speaking, when the linear speed of the diamond circular saw blade is high, a small cutting depth should be selected. From the current technology, the depth of the sawing diamond can be selected between 1 mm and 10 mm. When sawing granite blocks with large-diameter saw blades, the sawing depth can be controlled between 1mm and 2mm, and at the same time, the feed rate should be reduced. When the linear speed of the diamond circular saw blade is large, a large depth of cut should be selected. However, when the performance of the saw and the allowable range of tool strength, the cutting concentration should be taken as much as possible to improve the cutting efficiency. When there is a requirement for the machined surface, a small depth cut should be used.
2. Saw blade line speed: In actual work, the linear speed of the diamond saw blade is limited by the condition of the equipment, the quality of the saw blade and the nature of the sawed stone. From the optimum saw blade life and sawing efficiency, the linear speed of the saw blade should be selected according to the nature of the different stones. When sawing granite, the linear speed of the saw blade can be selected from 25m to 35m/s. For granite with high quartz content and difficult to saw, the lower limit of the blade line speed is appropriate. In the production of granite tiles, the diameter of the diamond circular saw blade is small, and the linear velocity can reach 35m/s.